Mill Diagnostic Electrician

• Removal, repair and installation of electrical systems and components within the following areas and systems: mill (primary/regrind), leach area, packing area, boiler room, reagent area, acid house, general mill, conveyor equipment, air, water and power line systems
• Perform equipment electrical analysis and diagnosis, advanced troubleshooting and systems/process optimization
• Work on switch gear and distribution including grounding, LOTOTO procedures, and use of jumper forms
• Perform preventative maintenance including checking motors, checking for ground loops, metering electrical circuits, calibrating equipment and completing additional checks
• Review, revise and create SOP’s
• Perform GRC conduit bending and fastening: conduit, cable tray, grounds, boxes, and calculating loads and feeder sizes
• Train and mentor other Electrical department employees on:
• Proper testing of PPE
• Proper audit of Mill site
• Preventative maintenance (either electrical or instrumentation)
• Product flow and priorities
• New electrical installation
• Print reading

• Act as Fill-in Supervisor as needed
• May be required to use the following mobile equipment: forklifts, light duty vehicles, bucket trucks, high-lift trucks
• Perform other duties as requiredMill Diagnostic Electrician Position Requirements 
• Completion of an approved Certified Electronics, Electrical and/or Instrumentation program, OR
• Minimum of four (4) years of experience in Industrial Electrical and/or Instrumentation repair and maintenance, OR
• Associate's degree or Trade School Certification in a related field and two (2) years of experience in Industrial Electrical and/or Instrumentation repair and maintenance
• Knowledge of AutoCAD drawings/prints, and electronic prints
• Knowledge of proper SOP's

Mill Diagnostic Electrician Position  Preferred Requirements 

• High School diploma or GED
• Experience with VFDs, PLC, HMI, and/or SCADA Control Systems
• Experience working with low and medium voltages
• Experience with AC and/or DC controls
• Experience with instrumentation devices
• Experience with diagnostic electrical test equipment
• Experience with HVAC equipment